Festo Контроллер позиционирования CPX-CMAX - Manual (Page 295)

6. Parametrisation
6−5
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
Error Error description Error Error description
0 Impermissible PNU.
1 Parameter value cannot be changed.
2 Lower or upper value limit exceeded.
3 Invalid subindex.
11 No higher−order controller. FCT must accept device control in order to write this parameter.
This error can only be generated via the service interface.
12 The password entered is wrong.
17 Request cannot be carried out due to operating status. Please check operating mode, stop
and enable signals.
101 Request ID is not supported.
102 Parameter cannot be read (password).
103 The system of measurement has not been configured yet. Access to the parameter is not
possible.
104 The cylinder type has not been configured yet. Access to the parameter is not possible.
105 The system of measurement has already been configured and cannot be changed without a
data reset.
106 Cylinder type cannot be changed since it does not match the system of measurement.
107 The value cannot be changed since there is identification data. Please reset the identification
data before writing the value.
108 The parameter value does not match the hardware recognised.
(Note: the cylinder type must match the measuring system)
109 Serial numbers cannot be changed before the identification data has been reset.
Tab. 6/5: Error numbers for parameter transmission