Festo Контроллеры двигателя SFC-LAC - Manual (Page 80)

4. The control panel (only type SFC−LACI−...−H2)
4−16
Festo GDCP−SFC−LACI−IO−EN en 0812NH
4.5.5 [Settings] [Jog Mode]
You can use the arrow keys to move the drive continuously
(also possible without previous reference run). The software
end positions have no effect here.
4.5.6 [Settings] [Password edit]
Access via the control panel can be protected by a (local)
password in order to prevent unauthorized or unintentional
overwriting or modification of parameters in the device. No
password has been preset at the factory (presetting = 000).
· Keep the password for the SFC−LACI in a suitable place,
e.g. in the internal documentation for your system.
If the active password in the SFC−LACI is lost:
The password can be deleted by entering a master password.
In this case please contact your Festo service partner.
Setting a password
Select [Password edit] in the menu [Settings]:
Enter a password with 3 digits. The current input position is
marked with a question mark.
1. Use the arrow keys to select a digit 0...9.
2. Confirm your input with <Enter>. The next entry position
will be displayed.
3. After entering the thirdĂdigit, save your setting with SAVE
<Enter>.
New Password:
[ ? x x ] = 0
ESC <Menu>
EDIT <––> SAVE <Enter>