Festo Контроллеры двигателя SFC-LAC - Manual (Page 205)

B. Supplementary information
B−43
Festo GDCP−SFC−LACI−IO−EN en 0812NH
Data memory control
CI 20F1h 01h...03h Array uint8 w
Description Commands for EEPROM
Delete EEPROM 01h
Fix: 16 (0x10): Delete data in EEPROM.
Once the object has been written, and after power off/on, the data in the
EEPROM are reset to the factory settings.
Save data 02h
The data in EEPROM will be overwritten with the current user−specific settings.
Fix 1 (0x01): Save data.
Reset device 03h
0x10: Reset device (EEPROM is not erased, state is identical to that after
switching off/on).
Note
All user−specific settings will be lost on deletion (except for
cycle number). The status after deletion corresponds to
the standard factory setting.
· After deleting the EEPROM, always carry out the steps
for commissioning the device.
Trace control
CI 20F2h 01h...0Ah Struct Various
Description Settings for recording positioning procedures using the Festo Configuration
Tool (FCT)