Festo Контроллеры двигателя SFC-LAC - Manual (Page 85)

5. Commissioning
5−3
Festo GDCP−SFC−LACI−IO−EN en 0812NH
5.1 Preparations for commissioning
Warning
There is a danger of injury.
Electric axes can move suddenly with high force and at
high speed. Collisions can lead to serious injury to human
beings and damage to components.
· Make sure that nobody can reach into the operating
range of the axes or other connected actuators (e.Ăg.
with a protective grille) and that no objects lie in the
positioning range while the system is still connected
to a power supply.
For commissioning, the mechanical system must be confiĆ
gured and a measuring reference system must be defined
(see Tab. 1/1). By means of the measuring reference system,
all positions are defined and movement can be made to
them, e.Ăg. with a positioning record from the position set
table.
· Carry out parametrising and commissioning by means of
the control panel or FCT, as described in the following
chapters and in the FCT/PlugIn help.
· Check the default settings in the [Diagnostic] menu.
· Upon completion of commissioning, note the instructions
for operation in the FCT/PlugIn help and in section 5.6.