Festo Контроллеры двигателя SFC-LAC - Manual (Page 76)

4. The control panel (only type SFC−LACI−...−H2)
4−12
Festo GDCP−SFC−LACI−IO−EN en 0812NH
4.5 Menu [Settings]
For parametrising the axis system and the positioning
records:
1. Select the entry [Settings] in the main menu. <ENTER>
2. Select a menu command. <ENTER>
[Settings] Description Section
[Axis type] The axis controlled by the SFC−LACI 4.5.1
[Axis parameter] Teach mode for setting the axis parameters 4.5.2
[Homing paramet.] Setting the homing travel method and the speed during homing
travel 4.5.3
[Position set] Teach mode for programming the position record table 4.5.4
[Jog mode] Jog mode: Moving by means of the arrow keys 4.5.5
[Password edit] Setting up a password for the control panel 4.5.6
Tab. 4/5: [Settings] menu
Note
The set parameters take effect immediately after confirmaĆ
tion with OK <ENTER>.
· Use [SAVE...] to permanently save the settings in EEĆ
PROM. Only then will the settings be retained even after
switching off the power supply or in the event of a power
failure.
} Settings
Axis type
Axis parameter
Homing paramet.
Position set
Jog mode
Password edit