Festo Контроллеры двигателя SFC-LAC - Manual (Page 47)

3. Installation
3−5
Festo GDCP−SFC−LACI−IO−EN en 0812NH
If unused plug connectors are touched, there is a danger that
damage may occur to the SFC−LACI or to other parts of the
system as a result of ESD (electrostatic discharge). Place proĆ
tective caps on unused terminal connections in order to preĆ
vent such discharges.
Overview of cables
Connection Cable Type
1 Parametrising interface Programming cable KDI−MC−M8−SUB−9−2.5
2 Controller interface Pilot line KES−MC−1−SUB−15−...
3 Power supply Power supply cable KPWR−MC−1−SUB−15HC−...
5 Local digital I/Os Connecting cable KM8−M8−... or NEBU−M8−...
6 Motor connection Motor cable NEBM−T1G6−T1G6−...
Encoder cable NEBM−T1G12−T1G12−...
Tab. 3/2: Overview of cables (accessories)
For complying with the IP protection class:
· Tighten the union nuts/locking screws on the plugs by
hand.
· Seal unused M8 connections with type ISK−M8 protective
caps (accessories).
Observe the tightening torques specified in the
documentation for the cables and plugs used.