Festo Контроллеры двигателя SFC-LAC - Manual (Page 56)

3. Installation
3−14
Festo GDCP−SFC−LACI−IO−EN en 0812NH
3.5 Parametrising interface
Serial interface for parametrizing, commissioning and diagĆ
nosing.
Note
For connecting a PC to the SFC−LACI, use only the cable
specified in Tab. 3/2.
· If necessary, remove the protective cap from the parameĆ
trising interface.
· Connect the following terminals with the programming
cable:
ć the socket on the SFC−LACI
ć a serial interface COMx of the PC.
M8 socket Description
1 2 4 3 1 GND Ground
2 RXD RS232 1) : Receiving cable of PC,
transmitting cable of SFC−LACI
3 TXD RS232 1) Transmitting cable of PC,
receiving cable of SFC−LACI
4 ć (reserved, do not use)
1) The levels correspond to the RS232 standard.
Tab. 3/7: Parametrising interface (RS232) of the SFC−LACI