Festo Контроллеры двигателя SFC-LAC - Manual (Page 36)

1. System overview
1−18
Festo GDCP−SFC−LACI−IO−EN en 0812NH
1.7 Commissioning options
You can parameterise and commission the SFC−LACI as
follows:
ć with the Festo Configuration Tool (FCT)
} Section 5.3
ć at the control panel (HMI, only type SFC−LACI−...−H2)
} Chapters 4 and 5.
Functions HMI FCT
Parametrisation Ĉ Drive and associated parameters
Ĉ Brake / clamping unit
Ĉ Uploading/downloading of configuration data
Ĉ Saving different configurations in projects x
ć
ć
ć x
x
x
x
Positioning
records Ĉ Compiling a positioning record table with set number,
target position, speed, acceleration etc.
x x
Commissioning Ĉ Reference run (homing)
Ĉ Teaching of positions
Ĉ Travel in individual steps
Ĉ Starting and stopping positioning procedures during
commissioning
Ĉ Extended test functions, e.g. status displays
Ĉ Testing or demonstrating the positioning records
(x)
x
x
x
(x)
x
x
x
x
x
x
x
Diagnostics/ Service Ĉ Reading and displaying diagnostic data
Ĉ Oscilloscope function (trace): Graphic presentation of
positioning procedures
x
ć x
x
Parametrisation can also be done via the parametrisation
interface using the objects of Command Interpreter"
(
} Section B.2). Only experienced users may operate the
module by means of CI commands.