Altera Embedded Peripherals IP - Manual (Page 296)

For more information about the System Console and its commands, refer to Analyzing and Debugging
Designs with the System Console in volume 3 of the Quartus II Handbook.
Parameters
Table 29-4: Configurable Parameters
Parameter Legal Values Default Value Description
Use PLI Simulation
Mode
— — Turn on this parameter to enable PLI
simulation mode. This PLI simulation mode
enables you to send and receive bytestream
commands, through System Console, while
the system is being simulated in ModelSim ® .
PLI Simulation
Port
1–65535 50000 Specifies the PLI simulation port number.
Document Revision History
Table 29-5: Document Revision History
Date and
Document
Version
Changes Made Summary of Changes
July 2014
v14.0.0 -Removed mention of SOPC Builder, updated to Qsys Maintenance Release
December
2010
v10.1.0
Updated SOPC Builder System with an Avalon-ST
JTAG Interface Core diagram.
Revised the operation description.
Added Parameters section.
Removed “Device Support”, “Instantiating the Core in
SOPC Builder”, and “Referenced Documents” sections.
—
July 2010
v10.0.0 No change from previous release. —
November
2009
v9.1.0
No change from previous release. —
March 2009
v9.0.0 No change from previous release. —
UG-01085
2014.24.07
Parameters 29-3
Avalon-ST JTAG Interface Core Altera Corporation
Send Feedback