Westermo RedFox Series - Manual (Page 157)

Westermo OS Management Guide
Version 4.17.0-0
Context web context.
Usage Configures the HTTPS (SSL) port.
Default values 443
7.3.46 Enable/disable IPConfig Service
Syntax [no] ipconfig
Context Global Configuration context.
Usage Enable IPConfig service interface (management of the unit via the West-
ermo IPConfig protocol), and enter IPConfig Configuration context. Use ”no
ipconfig” to disable the IPConfig server
Warning
After this the switch cannot be managed (or detected) via the IPConfig
protocol, used by the WeConfig tool.
Use ”show ipconfig” to list whether IPConfig is enabled or disabled. Note:
There is another ”show ipconfig” command available in the
Admin Exec
context, which is used (1) to scan for neighbour Westermo units, and (2)
to list status information on the IPConfig server running on this device, see
section 7.3.34 .
Default values Enabled (”ipconfig”)
Examples
1. How to check whether IPConfig service is enabled on my switch:
Example
example:/#> config
example:/config/#> show ipconfig
Ipconfig is enabled
Read only mode : Disabled
example:/config/#> end
2. How to enable/disable IPConfig service:
Enter Global Configuration context, check the current IPConfig configu-
ration, and modify it if desired. Below is an example of how to disable
IPConfig.
➞ 2015 Westermo Teleindustri AB 157