Westermo RedFox Series - Manual (Page 165)

Westermo OS Management Guide
Version 4.17.0-0
sometimes used to distinguish Ethernet port 1 (”eth 1”) from xDSL port 1
(”dsl 1”).
❼ RedFox Rail and Viper: Ethernet ports on RedFox Rail and Viper are named
X1, X2, X3, . . .
8.1.1.2 Slot based numbering
RedFox Industrial[ 47 , 48 ] and some Wolverine products (DDW-225[ 39 ] and DDW-
226[ 40 ]) use a slotted architecture, and ports are named according to the slot ID
and the port’s position within that slot. For example, port 1/2 would denote the
second port in the first slot.
This name convention is used irrespective of port type, e.g., DDW-226 (Wolverine)
has two SHDSL ports (1/1-1/2), 4 Ethernet ports (2/1-2/4), and one Serial port
(1/1). Details on the name convention and the slotted architecture is described
further below, using RedFox Industrial as example.
Figure 8.1: Three-slot RedFox Industrial switch equipped with a 8-port Gigabit/SFP
card (middle slot), and an 8-port 10/100BaseTX card (right slot).
The RedFox Industrial switches come in a two-slot and a three-slot version. Fig. 8.1
shows a sample three-slot RedFox Industrial equipped with a 4-port Gigabit/SFP
➞ 2015 Westermo Teleindustri AB 165