Westermo RedFox Series - Manual (Page 891)

Westermo OS Management Guide
Version 4.17.0-0
38.3.6 Setting Software flow control (XON/XOFF)
Syntax [no] xonxoff
Context Serial Port Configuration context
Usage Enable/disable software flow control using XON/XOFF
Use ”show xonxoff” to show the software flow control setting (XON/XOFF)
for this serial port.
Default value Disabled (no xonxoff)
38.3.7 Setting Hardware flow control (RTS/CTS)
Syntax [no] rtscts
Context Serial Port Configuration context (only applicable when the serial port
is operating in RS-232 mode)
Usage Enable/disable hardware flow control using RTS/CTS.
Use ”show rtscts” to show the hardware flow control setting (RTS/CTS) for
this serial port.
Default value Disabled (no rtscts)
38.3.8 Selecting serial protocol for a serial (combo) port
Syntax [no] type <rs232|rs422|rs485>
Context Serial Port Configuration context (Only applicable to ”combo” RS-232/422/485
and RS-422/485 serial ports. )
Usage Select serial protocol to use for a serial (combo) port. Use, e.g., ”type
rs422” to make a port operate in RS-422 mode. ”no type” resets to the
default type (RS-232 for RS-232/422/485 ports and RS-485 for RS-422/485
ports).
Use ”show type” to show whether the serial (combo) port is configured in
RS-232, RS-422, or RS-485 mode. (This is only of major interest for combo
RS-232/422/485 and RS-422/485 serial ports - a ”regular” RS-232” serial
port cannot be set to anything but RS-232.)
➞ 2015 Westermo Teleindustri AB 891