Westermo RedFox Series - Manual (Page 296)

Westermo OS Management Guide
Version 4.17.0-0
filters are only intended to be used for multicast MAC addresses (not unicast
MAC or the broadcast MAC addresses).
The ”PORTLIST” can include both visual ports (e.g., ”eth 2/1-2/4” on a
slotted WeOS unit) as well as the internal CPU port(s):
❼ PORT(S): Port, set of or range of ports, e.g. eth 1,3-5
❼ ALL: All visible ports, excluding internal CPU port(s)
❼ NONE: No ports, filter this MAC address
❼ CPU: The internal CPU port(s)
Use ”no MAC <MACADDRESS>” to remove a specific static MAC filter, or ”no
MAC” to remove all static MAC filters.
Use ”show mac” to list configured MAC address entries.
Default values (The factory default configuration includes a set of static MAC
filters.)
13.4.4 Managing general VLAN settings
Syntax [no] vlans
Context Global Configuration context
Usage Enter the General VLAN Configuration context (vlans). The General VLAN
Configuration context can be used to configure VLAN settings applicable to
all VLANs.
Use ”no vlans” to remove all VLANs except the switch default VLAN (VLAN 1).
All ports will be configured untagged on VLAN 1.
Use ”show vlans” to list all configured VLANs and general VLAN settings.
Default values Not applicable.
13.4.5 Enable dynamic VLAN
Syntax [no] dynamic <adaptive>
Context General VLAN Configuration context (vlans)
296 ➞ 2015 Westermo Teleindustri AB