Section 16.3.7, Section 16.3.8, Example – Westermo RedFox Series User Manual
Page 360: 7 enable spanning tree on a port, 8 admin edge setting
Westermo OS Management Guide
Version 4.17.0-0
Example
example:/config/spanning-tree/#> show stp-port all
Port
Enabled
Admin-Edge
Path-cost
==============================================================================
Eth 1
YES
NO
AUTO
Eth 2
YES
NO
AUTO
Eth 3
YES
YES
AUTO
Eth 4
YES
YES
AUTO
example:/config/spanning-tree/#>
16.3.7
Enable Spanning Tree on a Port
Syntax [no] enable
Context
Spanning Tree Port Configuration
context
Usage Enable the spanning tree protocol on a port. Use ”no enable” to disable
spanning tree protocol on a port.
Default values Enabled
16.3.8
Admin Edge Setting
Syntax [no] admin-edge
Context
Spanning Tree Port Configuration
context
Usage Configure the port as an access port (”no admin-edge”), or as an inter-
switch port (”admin-edge”).
Note
It is recommended that every port where it is certain that only end
hosts and routers connect (but not switches/bridges) are configured as
”admin-edge”. Port which (may) connect to another switch/bridge
should be configured as ”no admin-edge”.
Use ”show admin-edge” to view the admin edge setting for this port.
Default values Disabled (”no admin-edge”)
360
➞ 2015 Westermo Teleindustri AB