Westermo RedFox Series - Manual (Page 640)

Westermo OS Management Guide
Version 4.17.0-0
28.3.1 Activate RIP and Manage General RIP Settings
Syntax [no] rip
Context Router Protocol Configuration context
Usage Enter the Router RIP Configuration context, and activate RIP with default
settings if RIP is not activated already. Instead of running ”rip” from the
Router context, you can use ”router rip” directly from the Global Config-
uration
Use ”no rip” to disable RIP and delete all existing RIP configuration.
Use ”show rip” to show a summary of all general RIP settings. Also avail-
able as ”show” command within the
Router RIP Configuration context.
Default values Disabled (no rip)
28.3.2 Configure Default RIP Version
Syntax [no] version <1|2>
Context Router RIP Configuration context
Usage Select what RIP version (1 or 2) to use by default, both with respect to
sending and receiving of RIP messages. The setting can be overridden per
interface using the ”receive-version” (
section 28.3.14 ) and ”send-version”
( section 28.3.14 ) respectively.
Use ”no version” to return to the default setting.
Use ”show version” to show the default RIP version setting.
Default values RIPv2 (version 2)
28.3.3 Configure RIP Protocol Timers
Syntax [no] timers [update <SEC>] [invalid <SEC>] [flush <SEC>]
Context Router RIP Configuration context
Usage Several timers of the RIP protocol can be changed using the timers com-
mand. All timers take a value between <5-2147483647> seconds.
640 ➞ 2015 Westermo Teleindustri AB