Westermo RedFox Series - Manual (Page 434)

Westermo OS Management Guide
Version 4.17.0-0
If a name server is not configured using the ”name-server” command,
name server(s) (and domain search path) can be acquired dynamically from
an interface with DHCP address assignment.
Use ”show name-server” to show configured name servers.
Default values Disabled (”no name-server”) Running ”no name-server” (with-
out specifying any name removes all configured name servers.
19.7.6 Domain Search Path
Syntax [no] domain <DOMAIN>
Context IP Configuration context
Usage Add/remove domain search path. A single search path can be added.
Run ”no domain” to remove the domain search path.
If a name server is not configured using the ”name-server” command, do-
main(s) can be acquired dynamically from an interface with DHCP address
assignment.
Use ”show domain” to show configured domain search path.
Default values Disabled (”no domain”)
19.7.7 Enable/Disable DNS proxy service
Syntax [no] domain-proxy
Context IP Configuration context
Usage Enable or disable DNS proxy support. When enabled, the unit will act as
a DNS server and respond to DNS queries for known hosts:
❼ either statically added by the ”host” (
section 19.7.8 ), see also the
”show ip host” ( section 19.7.28 ) command, or
❼ hosts for which this unit acts as DHCP server (
chapter 22 ), see also the
”show dhcp-clients” ( section 22.3.20 ) command .
Furthermore, the unit will act as a caching DNS forwarder; DNS queries of
unknown hosts are forwarded to the unit’s own DNS server (see the ”show
434 ➞ 2015 Westermo Teleindustri AB