Westermo RedFox Series - Manual (Page 641)

Westermo OS Management Guide
Version 4.17.0-0
❼ The update timer controls the interval between sending unsolicited Re-
sponse Messages to all neighboring routers.
❼ The invalid timer controls the time before a route is expired and re-
moved from the kernel routing table. It is kept for ƒ sh − nd sec-
onds in the internal RIP routing table to notify neighbors that a route
has been dropped.
❼ The flush timer should be longer than the invalid timer. It controls the
time when a route is finally cleared from the routing table.
Important
All routers should have the same timings setup.
Use ”show timers” to show the configured RIP protocol timers.
Default values Use ”no timers” to return to the default timers:
update 30 sec
invalid 180 sec
flush 240 sec
Example
timers update 5 invalid 15 flush 30
This sends out updates every five seconds, invalidates a route if a router is not
heard from in 15 seconds and flushes the route after an additional 15 seconds.
28.3.4 Enable RIP on an Interface
Syntax [no] network <NETWORK/LEN | IFACE>
Context Router RIP Configuration context
Usage Enable RIP on the specified router interface. The interface can be speci-
fied either explicitly (”network <IFACE>”) or implicitly giving the IP subnet
associated with the interface (”network <NETWORK/LEN>”).
Use ”no network <IFACE>” and ”no network <NETWORK/LEN>” to remove
an existing ”network” entry.
➞ 2015 Westermo Teleindustri AB 641