Section 22.3.12, Section 22.3.13 – Westermo RedFox Series User Manual
Page 509
Westermo OS Management Guide
Version 4.17.0-0
Use ”address deny” to prohibit the host to be served by this DHCP server.
A host must either be assigned an IP address or explicitly be denied an
address. ”no address” is not a valid setting, i.e., then the host entry will
not be activated.
Use ”show address” to show the current address setting.
Default values None
22.3.12
Configure DHCP Server Subnet
Syntax [no] subnet <IPADDR[/LEN] | IPADDR [NETMASK]>
Context
context
Usage Specify a subnet for which the DHCP server will hand out IP addresses,
and enter the
DHCP Server Subnet Configuration
for that subnet. Optionally,
the subnet netmask can be specified as a prefix length or as a netmask,
with ”/24” (”255.255.255.0”) as default. It can later be changed with the
”netmask” command, see
Use ”no subnet” to remove all configured subnets, and use ”no subnet
IPADDR” to remove a specific subnet.
Use ”show subnet” to show a list configured subnets for the DHCP server,
and use ”show subnet IPADDR” to show information on a specific subnet
(alternatively, you can run the ”show” command within the
context of that specific subnet).
The DHCP server can handle up to 1024 subnets.
Default values Default prefix length is 24 (i.e., netmask 255.255.255.0).
22.3.13
Configure DHCP Subnet Netmask
Syntax [no] netmask <NETMASK>
Context
DHCP Server Subnet Configuration
context
Usage Specify/modify the netmask for the subnet to serve, e.g.,
”netmask 255.255.128.0”.
Use ”no netmask” to reset the netmask to its default value.
➞ 2015 Westermo Teleindustri AB
509