Westermo RedFox Series - Manual (Page 317)

Westermo OS Management Guide
Version 4.17.0-0
14.4 Managing FRNT settings via the CLI
Command Default Section
Configure FRNT settings
[no] frnt [ID]
Section 14.4.1
[no] focal-point focal-point Section 14.4.2
ring-ports <PORT-M, PORT-N> Section 14.4.3
Show FRNT status
show rings Section 14.4.4
show ipconfig Section 7.3.34
14.4.1 Managing FRNT
Syntax [no] frnt [<ID>]
Context Global Configuration context
Usage Enter FRNT context of the given FRNT instance ID. Currently only a single
FRNT instance is supported, thus the value of the FRNT ID is ignored.
The FRNT instance is only activated upon the selection of valid FRNT ring
ports, see
section 14.4.3 .
Use ”no frnt [ID]” to remove an existing FRNT instance.
Use ”show frnt” to list configured FRNT settings (also available as ”show”
command within the
FRNT Configuration context).
Default values Default ID is 1
14.4.2 FRNT focal point and member switch
Syntax [no] focal-point
Context FRNT Configuration context
Usage Configure device to act as FRNT focal point for this FRNT instance. Use
”focal-point” to configure the device to act as an FRNT focal-point, and
”[no] focal-point” to configure the device as an FRNT member switch.
➞ 2015 Westermo Teleindustri AB 317