Westermo RedFox Series - Manual (Page 730)

Westermo OS Management Guide
Version 4.17.0-0
Continued from previous page
Protocol The rule will be applied to traffic using this protocol. Se-
lect IP protocol in drop-down or enter the protocol number
to specify for which protocol to match with this rule (see
also Destination Port option below). Select any to match
any IP Protocol (ICMP, TCP, UDP, . . . ).
Source
Address(es) The rule will be applied to traffic originating from a source
with this specific IP-address or an IP-address in the speci-
fied subnet. Select Single and enter the single source ad-
dress into the address field. Select Subnet and enter an
address into the address field and a subnet mask into the
Netmask field.
Destination
Address(es) The rule will be applied to traffic destined to this specific
IP-address or to an IP-address in the specified subnet. Se-
lect Single and enter the single source address into the
address field. Select Subnet and enter an address into
the address field and a subnet mask into the Netmask
field.
Destination Port The rule will be applied to traffic destined to this set of
(UDP/TCP) ports. If JavaScript is enabled, the range start
may be selected in the drop down. Only valid if Protocol
TCP or UDP has been selected (see above).
DSCP - Set Value The DSCP value to be set for packets matching this rule.
Valid values 0-63.
DSCP Adjust Priority Indicates if the modified DSCP value should be used for
switch internal prioritising and applied to VLAN-priority on
tagged packets. Check to enable.
730 ➞ 2015 Westermo Teleindustri AB