Westermo RedFox Series - Manual (Page 399)

Westermo OS Management Guide
Version 4.17.0-0
Interface Default Setting
Parameters vlan<VID> pppoe<ID> modem<ID> 2
Administrative Mode Enabled Enabled Enabled
IP address
Static 1 Dynamic 3 Dynamic 3
Disabled (IPCP) (IPCP)
Netmask Disabled N/A N/A
MAC address Auto N/A N/A
MTU Auto (1500) 1492 4 Auto (1500)
Admin Distance 16 ”Inherited” 16
TCP-MSS Disabled 1412 Disabled
Management Interface Enabled 5 ”Inherited” Enabled 4
Interface Default Setting
Parameters gre<ID> ssl<ID>
Administrative Mode Enabled Enabled
IP address
Static Static
Disabled Disabled
Netmask Disabled Disabled
MAC address N/A Auto 6
MTU 1476 Auto (1500)
Admin Distance 16 16
TCP-MSS Disabled Disabled
Management Interface Enabled 5 Enabled 5
The interface admin distance and management interface concepts are described
in
sections 19.2.6 and 19.2.7 .
VLAN network interfaces will be named according to the associated VLAN ID, e.g.,
the interface of VLAN 100 will be named vlan100. PPP, GRE and SSL interfaces will
1 The exception is interface vlan1 (VID 1). If vlan1 does not exist, or if it is created without an
address method defined, vlan1 will default to acquire its address dynamically via DHCP.
2 Interfaces for PPP over serial port (modem<ID>) are only available for products equipped a
serial port.
3 For PPP interfaces, the IP address assignment is handled by the PPP configuration, see sec-
tion 33.1.7 .
4 When using PPPoE the default PPP interface MTU is 8 bytes less than the associated VLAN
interface MTU, which is typically 1500 bytes.
5 On new interfaces, all management services except Telnet are allowed by default.
6 Only layer-2 SSL interfaces have MAC addresses. As of WeOS v4.17.0 the auto mode picks a
random MAC address, however, this may change in the future WeOS releases.
➞ 2015 Westermo Teleindustri AB 399