Westermo RedFox Series - Manual (Page 935)

Westermo OS Management Guide
Version 4.17.0-0
40.2 Managing Modbus Gateway via the CLI interface
The table below shows Modbus Gateway management features available via the
CLI.
Command Default Section
Configure Modbus Gateway settings
modbus
Section 40.2.1
[no] mode <server|client> server Section 40.2.2
[no] port <SERIAL-PORT> Disabled Section 40.2.3
[no] serial-protocol <rtu|ascii> rtu Section 40.2.4
[no] listen <IFACE> [port <PORT>] Disabled Section 40.2.5
[no] rtu-interval <MILLISECONDS> 50 Section 40.2.7
[no] ascii-timeout <MILLISECONDS> 1000 Section 40.2.6
[no] poll-interval <MILLISECONDS> 50 Section 40.2.8
[no] error-check Enabled Section 40.2.9
[no] inactivity-timeout <SECONDS> Disabled Section 40.2.10
[no] response-timeout <MILLISECONDS> 500 Section 40.2.11
[no] broadcast-delay <MILLISECONDS> 100 Section 40.2.12
[no] redirect <MODBUS-ADDR> Disabled Section 40.2.13
[no] redirect-broadcast Disabled Section 40.2.14
[no] request-queue Enabled Section 40.2.15
[no] exceptions [ignore-unknown] Enabled Section 40.2.16
[no] map unit <MODBUS-ADDR> N/A Section 40.2.17
address <IPADDRESS>[:<PORT>]
Show Modbus Gateway settings
modbus
show Section 40.2.18
show mode Section 40.2.19
show port Section 40.2.20
show serial-protocol Section 40.2.21
show listen Section 40.2.22
show rtu-interval Section 40.2.23
show ascii-timeout Section 40.2.24
show poll-interval Section 40.2.25
show error-check Section 40.2.26
Continued on next page
➞ 2015 Westermo Teleindustri AB 935