Westermo RedFox Series - Manual (Page 598)

Westermo OS Management Guide
Version 4.17.0-0
26.3 Enabling Routing, Managing Static Routing, etc.,
via CLI
The table below shows WeOS CLI commands relevant for handling static routing.
The detailed description of these commands is found in other chapters as listed
in the table.
Dynamic routing (RIP and OSPF) and other router related protocols (VRRP) share
a common router configuration context which is also listed in the table.
Command Default Section
Configure general routing settings
ip
Section 19.7.1
[no] default-gateway <IPADDR> DEPRECATED Section 19.7.2
[no] route <NETWORK NETMASK| Section 19.7.3
NETWORK/LEN> <GATEWAY|IFNAME>
[DISTANCE]
DISTANCE 1
[no] forwarding Enabled Section 19.7.4
router Section 26.3.1
[no] ospf Section 27.3
[no] rip Section 28.3
[no] vrrp <ID> Section 30.3
Show general routing status
show ip route
Section 19.7.25
26.3.1 Manage Router Protocols
Syntax router
Context Global Configuration context
Usage Enter the Router Protocol Configuration context. From here you can con-
figure dynamic routing protocols such as OSPF ( section 27.3 ) and RIP ( sec-
tion 28.3 ) and, as well as other router related protocols such as VRRP ( sec-
tion 30.3 ).
Use ”show router” to list general router protocol settings (also available
”show” command within the
Router Protocol Configuration context.
598 ➞ 2015 Westermo Teleindustri AB