MacDon M205 Operators Manual - Manual (Page 100)

OPERATOR’S STATION
Display (A) Flashing Alarm Tone Description
NO OPERATOR / NOT IN
PARK
ENGINE SHUTDOWN
Continuous tone
Operator not detected in seat
with header engaged or out of
N-DETENT with machine moving
at <5mph (8 km/h): engine
shutdown after 5 seconds
NO OPERATOR Continuous tone
Engine shutdown when Operator
not detected in seat with machine
moving >5 mph (8 km/h)
NOT IN PARK X Short beep with each flash
GSL or interlock switches not
closed with key ON / engine OFF
PLACE GSL INTO “N”
Beeps at 2 per second until
corrected GSL or interlock switches not
closed with key ON / engine OFF
SLOW DOWN X Short beep with each flash
Ground speed is greater than
or equal to 25 mph (40 km/h):
Operator should pull back on the
GSL to reduce ground speed
TRANS OIL PRESS X
Continuous loud tone until oil
pressure is regained Low transmission charge oil
pressure
TRANS OIL TEMP X
Ongoing intermittent moderate
tone until temperature is below
acceptable level
Transmission oil temperature
above 221°F (105°C)
##.# LOW VOLTS X Single loud tone for 10 seconds Voltage below 11.5
##.# HIGH VOLTS X Single loud tone for 10 seconds Voltage above 15.5
169887 84 Revision A