MacDon M205 Operators Manual - Manual (Page 124)

OPERATOR’S STATION
4. Press SELECT (D) until SET TIRE SIZE? is displayed
on the upper line.
• Currently installed tire size is displayed on the
lower line.
NOTE:
The following tire sizes are available:
• 18.4 x 26 TURF
• 18.4 x 26 BAR
• 23.1 x 26 TURF
• 600 – 65 R28
• 580 / 70 R26 TURF
5. Press left (B) or right (C) arrow and select tire size.
Press SELECT (D).
6. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
Figure 3.118: Selecting Tire Size
Setting the Engine Intermediate Speed Control (ISC) RPM
NOTE:
• The ISC sets the engine speed when the header is engaged. For more information, refer to Engine Intermediate
Speed Control (ISC), page 154 .
• Engine MUST be running to perform this procedure.
1. Start the engine. Refer to Starting the Engine, page
152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
Figure 3.119: CDM Programming Buttons
169887 108 Revision A