MacDon M205 Operators Manual - Manual (Page 278)

OPERATION
4.7.1 Auger Speed
Auger Speed on A30-D Headers
On A30-D Auger Headers, the auger speed is fixed to the knife speed. The auger speed is NOT monitored
and cannot be displayed.
Setting the Auger Speed on A40-D Headers
Figure 4.230: Operator Console
CAUTION
Check to be sure all bystanders have cleared the area.
To set the auger speed, follow these steps:
1. Engage header.
2. Set the HEADER INDEX switch (B) to OFF.
3. Press DISPLAY SELECTOR switch (E) on the ground speed lever (GSL) or press FAST (C) or SLOW (D) on
the cab display module (CDM) until ##.# AUGER SPEED is displayed at (A).
The displayed value (##.#) = auger speed setting.
NOTE:
Changes to reel speed will affect the auger speed directly. However, when adjusting reel speed, the auger
speed value displayed on the CDM will not change.
4. Press FAST (C) or SLOW (D) on the CDM until the desired auger speed is achieved.
169887 262 Revision A