MacDon M205 Operators Manual - Manual (Page 123)

OPERATOR’S STATION
4. Press SELECT (D) until HEADER REEL SPEED? is
displayed on the upper line.
• RPM/MPH is displayed on the lower line.
5. Press left (B) or right (C) arrow to select either Imperial
or Metric units. Press SELECT (D).
6. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
Figure 3.116: Selecting Reel Speed Display
Setting the Windrower’s Tire Size
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
Figure 3.117: CDM Programming Buttons
169887 107 Revision A