MacDon M205 Operators Manual - Manual (Page 115)

OPERATOR’S STATION
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed.
• The current knife speed is displayed on the
lower line.
Figure 3.99: CDM Programming Buttons
4. Press left (B) or right (C) arrows to select knife speed.
Press SELECT (D).
5. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
Figure 3.100: Selecting Knife Speed
Setting the Hydraulic Overload Pressure
NOTE:
• This procedure requires installation of the optional Pressure Sensor (MD #B5574). For overload pressure values,
refer to Pressure Sensor installation instructions (MD #169031).
• To enable sensor, refer to Switching the Installed Header Sensors On or Off, page 122 .
169887 99 Revision A