MacDon M205 Operators Manual User Manual
Page 332
IMPORTANT:
Clean the area around the plastic cap to ensure nothing
falls into gearbox oil reservoir.
5. Clean the area around the plastic cap on access
hole (A). Remove the cap.
6. Insert the barring tool (B) into the flywheel housing until
it engages the ring gear.
7. Attach a 1/2 in. square drive ratchet or breaker bar
and turn.
8. Remove barring tool (B) and clean oil from around
access hole.
9. Clean plastic cap and reinstall in access hole (A) with
silicone sealant.
Figure 5.66: Access Hole Location for
Barring Tool
IMPORTANT:
BATTERY IS NEGATIVE GROUNDED. Always connect
starter cable to the positive (+) terminal of battery and
battery ground cable to negative (-) terminal of battery.
Reversed polarity in battery or alternator may result in
permanent damage to electrical system.
10. Attach negative (black) cables (B) to negative posts
on batteries, and tighten clamps. Then attach positive
(red) cables (A) to positive post on batteries and
tighten clamps.
11. Position plastic covers onto clamps.
12. Close the hood,refer to
13. Close platform, refer to
Figure 5.67: Battery Terminal Location
169887
316
Revision A