MacDon M205 Operators Manual - Manual (Page 95)

OPERATOR’S STATION
Cab-Forward, Engine Running, Header Engaged, Rotary Header Installed
Scroll through display with cab display module (CDM) switch or ground speed lever (GSL) switch.
Display (lower or upper line) Description
#####.# ENGINE HRS Total engine operating time.
#####.# HEADER HRS Total header operating time.
##.# ACRES/HOUR
##.# HECTARES/HOUR (If Metric) Actual cutting rate in acres (hectares)/hour.
###.# SUB ACRES
###.# SUB HECTARES (If Metric) Area cut since last reset. To reset, display SUB ACRES on lower line,
and hold down program switch until display resets (5–7 seconds).
###### TOTAL ACRES
###### TOTAL HECT (If Metric) Total area cut by machine.
#### DISC RPM
##.## DISC SENSOR Disc rotational speed.
Sensor Disabled. RPM and SENSOR alternate at 1 second intervals.
##.# HEADER HEIGHT
##.# HEIGHT SENSOR Distance setting (00.0–10.0) between cutterbar and ground.
Sensor Disabled. HEIGHT and SENSOR alternate at 1 second
intervals.
##.# HEADER ANGLE
##.# HEADER SENSOR Angle setting (00.0–10.0) header relative to ground.
Sensor Disabled. ANGLE and SENSOR alternate at 1 second intervals.
##.# L FLOAT R ##.#
FLOAT SENS DISABLED Left and right float setting (0.0–10.0).
Sensor Disabled.
LOAD|■■■■| | #### Bar graph representing hydraulic operating pressure. Full scale
is pre-programmed overload pressure (2500–5000 psi). If sensor
disabled, LOAD does not display
5 .
### °C or F HYD OIL TEMP
### °C or F HYD TEMP Hydraulic oil temperature.
Sensor Disabled. TEMP and SENSOR alternate at 1 second intervals.
##.# VOLTS Engine electrical system operating voltage.
SCROLL
SUB-MENU (Lower Line Only)
#### DISC RPM
##.# HEADER HEIGHT
LOAD|■■■■|■■■■| #### Displays sub-menu after 2–3 seconds. Press SELECT to cancel.
Scroll through sub-menu display with CDM switch.
Miscellaneous Operational Information
Scroll through display with cab display module (CDM) switch or ground speed lever (GSL) switch.
Display (upper line) Description
HEADER DISENGAGED Header drive is disengaged.
##.# FOOT DISK
AUGER or DRAPER will appear in place of DISK, depending on type
of header attached.
5. The LOAD sensor to monitor knife/conditioner circuit pressure is optional-installed. To monitor reel/auger circuit pressure,
relocate sensor as per Form MD #169031, which is available through your Dealer.
169887 79 Revision A