MacDon M205 Operators Manual - Manual (Page 474)

INDEX
auto raise height ......................................... 105
double windrower attachment (DWA) ........... 103
drive manifold ............................................. 103
engine intermediate speed control
(ISC) ........................................................ 108
header cut width ......................................... 102
header index mode ..................................... 100
hydraulic overload pressure ........................... 99
knife overload speed ..................................... 97
knife speed................................................... 98
return to cut mode....................................... 101
rotary disc overload speed............................. 98
tire size ...................................................... 107
troubleshooting
activating hydraulic purge ............................ 133
forcing a Header ID ..................................... 124
header sensors ........................................... 122
sensor input signals .................................... 123
testing double windrower attachment
(DWA) ...................................................... 141
testing draper drive ..................................... 136
testing header tilt ........................................ 129
testing header up/down ............................... 126
testing knife drive ........................................ 134
testing reel drive ......................................... 138
testing reel fore-aft ...................................... 131
testing reel up/down function ....................... 128
testing rotary disc drive................................ 139
windrower error codes
engine error codes................................... 120
warning/alarms................................................. 81
cab temperature, See HVAC system
California proposition 65......................................... 2
CanWin
cab display module (CDM)
error codes ................................................. 453
caster wheel, See wheel and tire
CDM, See cab display module (CDM)
center-link ........................................................... 29
See also hydraulic link
See also mechanical link
definition.......................................................... 29
self-locking center-link hook mechanism .......... 193
circuit breaker
accessing ...................................................... 378
replacing........................................................ 379
climate control system, See HVAC system
climate controls ................................................... 57
component location.............................................. 36
console ............................................................... 39
conversion chart ................................................ 286
cutting height..................................................... 195
D
D-Series header
attaching........................................................ 202
header boots .............................................. 248
attaching to M205........................................... 202
deck shift ....................................................... 258
deck shift (optional)
setting float options ..................................... 258
draper index
setting draper index..................................... 254
draper speed.................................................. 252
setting draper speed ................................... 252
setting independent of ground speed............ 255
setting minimum draper speed ..................... 253
header float
float options with deck shift .......................... 258
header position ....................................... 248–249
hydraulic center-link with optional
self-alignment kit
attaching to M205 ....................................... 202
hydraulic center-link without self-alignment kit
attaching to M205 ....................................... 207
knife speed
setting knife speed “on the go” ..................... 257
reel fore-aft position........................................ 249
reel height...................................................... 249
reel speed...................................................... 249
reel index ................................................... 249
reel minimum speed.................................... 249
reel only speed ........................................... 251
reel to ground speed ................................... 249
setting draper to ground speed........................ 252
decal
fuse box decal................................................ 380
GSL header switch functions............................. 68
location of safety signs ..................................... 14
deck shift - D-Series header ............................... 258
declaration of conformity ......................................... i
definition of terms ................................................ 29
double windrow attachment (DWA) ..................... 200
deck position.................................................. 200
draper speed.................................................. 201
draper index
setting for D-Series header ............................. 254
draper speed
setting for D-Series header ............................. 252
setting independent of ground speed ............... 255
setting minimum draper speed ........................ 253
drive wheel
installing ........................................................ 399
driving the windrower ......................................... 157
cab-forward operation..................................... 160
driving on road ............................................... 167
engine-forward operation ................................ 162