MacDon M205 Operators Manual - Manual (Page 243)

OPERATION
12. Remove lynch pin from clevis pin (A) in stand (B).
13. Hold stand (B) and remove pin (A).
14. Position stand to storage position by inverting stand
and relocating on bracket as shown. Reinsert clevis
pin (A) and secure with lynch pin.
Figure 4.160: Header Stand
15. Remove clevis pin from storage position (B) in linkage,
and insert in hole (A) to engage float springs. Secure
with hairpin.
Figure 4.161: Header Lift Linkage
16. Disengage safety prop by turning lever (A) downward
to release and lower safety prop until lever locks into
vertical position.
17. Repeat for opposite safety prop.
Figure 4.162: Safety Prop
169887 227 Revision A