MacDon M205 Operators Manual - Manual (Page 234)

OPERATION
3. If necessary, activate the REEL UP switch (A) on the
GSL to raise the center-link, so that the hook is above
the attachment pin on the header.
IMPORTANT:
If the center-link is too low, it may contact the header as
the windrower approaches the header for hookup.
Figure 4.138: GSL
4. Slowly drive the windrower forward so the feet (A)
on the windrower enter the boots (B) on the header.
Continue to drive slowly forward until the feet engage
the boots and the header nudges forward.
Figure 4.139: Header Boot
5. Use the following GSL functions to position the
center-link hook above the header attachment pin:
• Reel up (A) to raise the center-link
• Reel down (B) to lower the center-link
• Header tilt up (C) to retract the center-link
• Header tilt down (D) to extend the center-link
Figure 4.140: GSL
169887 218 Revision A