MacDon M205 Operators Manual - Manual (Page 102)

OPERATOR’S STATION
NOTE:
Contact your MacDon Dealer for information regarding software updates to the electronic modules. Your Dealer
will have the necessary interface tools and access to the latest software upgrades.
NOTE:
The following menus are available when ignition key is set to RUN:
• WINDROWER SETUP
• CAB DISPLAY SETUP
• DIAGNOSTIC MODE
The CALIBRATE SENSORS menu is available only when engine is running.
3.18.6 Cab Display Options
The display and sound features of the cab display module (CDM) can be adjusted to suit each particular Operator.
Setting the Cab Display Language
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
Figure 3.68: CDM Programming Buttons
3. Press SELECT (B) until CAB DISPLAY SETUP? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
Figure 3.69: Selecting Cab Display Setup
169887 86 Revision A