MacDon M205 Operators Manual - Manual (Page 110)

OPERATOR’S STATION
4. Press right (B) arrow to select Yes. Press SELECT (C).
• TO CALIBRATE SELECT is displayed in upper line
5. Press left (A) or right (B) arrow until HEADER TILT is
displayed on the lower line. Press SELECT (C).
• HDR TILT SENSOR CAL is displayed on the
upper line.
• EXTEND TILT TO START is displayed on the
lower line.
Figure 3.88: Calibrate Header Tilt
CAUTION
Check to be sure all bystanders have cleared the area.
6. Press and hold the HEADER TILT EXTEND (B) button
on the ground speed lever (GSL).
• CALIBRATING TILT is displayed on the upper line.
• EXTEND TILT HOLD is displayed on the lower line.
NOTE:
The word HOLD will flash during calibration. HEADER
TILT DONE will display on the lower line once calibration
is complete.
7. Release the HEADER TILT EXTEND (B) button.
• HEADER TILT SENSOR CAL is displayed on
upper line.
• PRESS RETRACT TILT is displayed on the
lower line.
Figure 3.89: Header Tilt Controls on Ground
Speed Lever
169887 94 Revision A