MacDon M205 Operators Manual - Manual (Page 103)

OPERATOR’S STATION
4. Press right (C) arrow select YES. Press SELECT (D).
• DISPLAY LANGUAGE? is displayed on the
upper line.
• Default language is displayed on the lower line.
5. Press left (B) or right (C) arrow to select
preferred language.
NOTE:
English, Russian, and Spanish language options are
available on windrowers. Not all options are available on
all windrowers.
6. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next CAB DISPLAY
SETUP? action. Figure 3.70: Selecting Display Language
Changing the Windrower Display Units
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
Figure 3.71: CDM Programming Buttons
3. Press SELECT (B) until CAB DISPLAY SETUP? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
4. Press right (A) arrow to select YES. Press SELECT (B).
• DISPLAY LANGUAGE? is displayed on the
upper line.
Figure 3.72: Selecting Cab Display Setup
169887 87 Revision A