MacDon M205 Operators Manual - Manual (Page 128)

OPERATOR’S STATION
6. Press SELECT (D) until DISK SPEED is displayed on
the upper line.
• ENABLED/LOCKED is displayed on the lower line.
7. Press left (B) arrow to enable DISK SPEED
control switch.
Press right (C) arrow to lock DISK SPEED
control switch.
8. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
Figure 3.127: Set Disc Speed Control Lock
Activating the Header Float Control Lock Out
NOTE:
Header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to
4.5 Attaching and
Detaching Headers, page 202 .
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
Figure 3.128: CDM Programming Buttons
4. Press SELECT (B) until SET CONTROL LOCKS? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
5. Press right (A) arrow to select YES. Press SELECT (B).
Figure 3.129: Set Control Locks
169887 112 Revision A