MacDon M205 Operators Manual - Manual (Page 326)

MAINTENANCE AND SERVICING
2. Separate the filter (B) from the cover (A).
3. Clean or replace filter. If cleaning filter, refer to
Cleaning Return Air Cleaner, page 310 .
4. Assemble the cleaner (B) and cover (A), and position
on cab wall over opening.
Figure 5.55: Return Air Filter
5. Secure filter assembly (B) to cab wall with knobs (A).
Figure 5.56: Return Air Filter
Cleaning Return Air Cleaner
Clean the electrostatic filter as follows:
1. Mix a solution of warm water and detergent in a
suitable container so that the filter (B) can soak for a
few minutes.
2. Agitate to flush out the dirt.
3. Rinse with clean water, and then dry with
compressed air.
4. Inspect filter for damage, separation, and holes.
Replace if damaged.
Figure 5.57: Return Air Filter
169887 310 Revision A