MacDon M205 Operators Manual - Manual (Page 423)

MAINTENANCE AND SERVICING
5.7.11 Maintenance Schedule
The Maintenance Schedule specifies the recommended periodic maintenance procedures and service intervals.
Regular maintenance is the best insurance against early wear and untimely breakdowns. Following this schedule
to maximize machine life.
For detailed instructions, refer to the various procedures in this chapter. Use the fluids and lubricants specified in
5.3.1 Recommended Fuel, Fluids, and Lubricants, page 284 .
Service Intervals: The recommended service intervals are in hours of operation. Where a service interval is given
in more than one time frame, for example 100 hours or annually, service the machine at whichever interval is
reached first.
IMPORTANT:
Recommended intervals are for average conditions. Service the machine more often if operated under adverse
conditions (severe dust, extra heavy loads, etc.).
CAUTION
Carefully follow safety messages given in 1 Safety, page 1 .
Break-In Inspections
Break-in inspections
Hours Item Check
1 Drive wheel nuts
Torque: 375 ft·lbf (510 N·m) dry
Repeat checks at one hour intervals until
torque stabilizes at two consecutive checks
A/C compressor belt Tension
Caster wheel nuts Torque: 120 ft·lbf (163 N·m)
Caster wheel anti-shimmy dampener bolts
Inboard bolt torque: 100 ft·lbf (135 N·m)
Outboard bolt torque: 85 ft·lbf (115 N·m)
5
Walking beam width adjustment bolts Torque: 330 ft·lbf (448 N·m)
Walking beam width adjustment bolts Torque: 330 ft·lbf (448 N·m)
10
Neutral Dealer adjusted
Hose clamps: air intake / radiator / heater /
hydraulic
Hand-tighten unless otherwise noted
Walking beam width adjustment bolts Torque: 330 ft·lbf (448 N·m)
Caster wheel anti-shimmy dampener bolts
Inboard bolt torque: 100 ft·lbf (135 N·m)
Outboard bolt torque: 85 ft·lbf (115 N·m)
Drive wheel lubricant
Main gearbox oil
Charge system oil filter
50
Return oil filter (if applicable)
Change
169887 407 Revision A