MacDon M205 Operators Manual - Manual (Page 155)

OPERATOR’S STATION
5. Press SELECT (B) until ACTIVATE FUNCTIONS? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
6. Press right (A) arrow to select YES. Press SELECT (B).
• ACTIVATE HEADER HT is displayed on the
upper line.
Figure 3.194: Selecting Activate Functions
CAUTION
Check to be sure all bystanders have cleared the area.
7. Press SELECT (E) until REEL DRV SPD XXXX is
displayed on the upper line.
IMPORTANT:
Do NOT over speed the reel drive.
8. Press and hold HAZARD (C) button.
• Press left (B) arrow to decrease reel drive speed.
• Press right (D) arrow to increase reel drive speed.
Verify the reel drive is functioning properly.
9. Release the HAZARD (C) button. The reel drive
will stop.
Figure 3.195: Activating Reel Drive
10. Press PROGRAM (A) to exit Programming Mode or
press SELECT (E) to proceed to next ACTIVATE
FUNCTION.
Testing the Rotary Disc Drive Circuit using the Cab Display Module (CDM)
IMPORTANT:
Do not over speed a drive for a significant length of time. Doing so can lead to vibration, belt failures, or
other over speeding related problems.
NOTE:
• A rotary disc header MUST be attached to windrower to follow this procedure.
• Engine MUST be running to perform this procedure.
169887 139 Revision A