4closing platforms (major service position), Closing platforms (major service position) – MacDon M205 Operators Manual User Manual
Page 311
3. Remove the nut and bolt that secure link (A) to the
frame. Swing link (A) out of the way.
4. Pull the front (cab-forward) end of platform away from
frame while moving it towards the walking beam. The
aft corner of platform (B) should project slightly into the
engine bay when the opening is optimum.
Figure 5.26: Platforms
5.5.4
Closing Platforms (Major Service Position)
CAUTION
Do NOT stand on an unlocked side platform. It is unstable and may cause you to fall.
1. Swing link (A) all the way forward.
2. Push the front (cab-forward) end of platform towards
the frame while moving the platform forward
(cab-forward).
3. Position link (A) on bracket and install bolt and nut.
Tighten enough so that link can still swivel on bracket.
Figure 5.27: Platforms
4. Move platform (B) forward (cab-forward) until it stops
and latch (A) engages.
5. Close the hood. Refer to
.
Figure 5.28: Platform Latch
169887
295
Revision A