MacDon M205 Operators Manual - Manual (Page 143)

OPERATOR’S STATION
3. Press SELECT (B) until DIAGNOSTIC MODE? is
displayed in upper line.
• NO/YES is displayed on the lower line.
4. Press right (A) arrow to select Yes. Press SELECT (B).
Figure 3.164: Selecting Diagnostic Functions
5. Press SELECT (B) until ACTIVATE FUNCTIONS? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
6. Press right (A) arrow to select YES. Press SELECT (B).
Figure 3.165: Selecting Activate Functions
CAUTION
Check to be sure all bystanders have cleared the area.
7. Press SELECT (D) until ACTIVATE HEADER HT is
displayed on the upper line.
• DOWN/UP is displayed on the lower line.
8. Press and hold left (B) arrow to lower header. Press
and hold right (C) arrow to raise header.
Verify header is functioning properly.
9. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next ACTIVATE
FUNCTION.
Figure 3.166: Changing Header Height
169887 127 Revision A