MacDon M205 Operators Manual - Manual (Page 231)

OPERATION
9. Disconnect header drive hydraulics (A) and electrical
harness (B) from header and store in support on
windrower left cab-forward side. Refer to the draper
header operator’s manual for further information.
Figure 4.130: Header Drive Hydraulics
10. Disconnect reel hydraulics (A) from header and
store on bracket at windrower left cab-forward side.
Refer to the draper header operator’s manual for
further information.
Figure 4.131: Reel Hydraulics
CAUTION
Check to be sure all bystanders have cleared the area.
11. Start engine and activate HEADER TILT cylinder
switch on ground speed lever (GSL) to release load
on center-link cylinder.
Figure 4.132: GSL
A - Header Tilt Up B - Header Tilt Down
169887 215 Revision A