MacDon M205 Operators Manual - Manual (Page 219)

OPERATION
3. If necessary, activate the REEL UP switch (A) on the
GSL to raise the center-link, so that the hook is above
the attachment pin on the header.
IMPORTANT:
If the center-link is too low, it may contact the header as
the windrower approaches the header for hookup.
Figure 4.99: GSL
4. Slowly drive the windrower forward so the boots (A)
enter the header legs (B). Continue to drive slowly
forward until lift linkages contact the support plates in
the header legs and the header nudges forward.
5. Ensure that lift linkages are properly engaged in header
legs, contacting the support plates.
Figure 4.100: Header Leg and Boot
6. Use the following GSL functions to position the
center-link hook above the header attachment pin:
• Reel up (A) to raise the center-link
• Reel down (B) to lower the center-link
• Header tilt up (C) to retract the center-link
• Header tilt down (D) to extend the center-link
Figure 4.101: GSL
169887 203 Revision A