Inspecting and cleaning fresh air filter element, Installing fresh air filter – MacDon M205 Operators Manual User Manual
Page 324
3. Remove filter (A) from tray (B).
Figure 5.51: Fresh Air Filter
Inspecting And Cleaning Fresh Air Filter Element
1. Tap the sides of the filter element gently to loosen dirt. Do NOT tap element against a hard surface.
2. Using a Dry Element Cleaner Gun, clean element with compressed air.
3. Hold the air nozzle next to the filter element’s inner surface and move up and down pleats.
4. Repeat previous steps to remove additional dirt as required.
5. Hold a bright light inside the element and check carefully for holes. Discard any element that shows the
slightest hole.
6. Check outer screen for dents. Vibration would quickly wear a hole in the filter.
7. Check filter gasket for cracks, tears, or other signs of damage. If gasket is damaged or missing, replace element.
IMPORTANT:
Air pressure must NOT exceed 60 psi (414 kPa). Do NOT direct air against outside of element, as dirt might be
forced through to inside.
Installing Fresh Air Filter
1. Clean tray (B) and interior of filter housing.
2. Place filter (A) onto tray (B).
Figure 5.52: Fresh Air Filter
169887
308
Revision A