MacDon M205 Operators Manual - Manual (Page 209)

OPERATION
Figure 4.82: Operator Console
A - Program Button B - Display C - Header Tilt Down
D - Header Tilt Up E - Display Selector
Adjust the header angle as follows:
• To decrease (flatten) header angle, operate HEADER TILT UP switch (D) on ground speed lever (GSL) handle so
that cylinder retracts. The CDM display will show a reading on the lower line of decreasing value between 00.0
and 10.0.
• To increase (steepen) header angle, operate HEADER TILT DOWN switch (C) on GSL handle so the cylinder
extends. The CDM display will show a reading on the lower line of increasing value between 00.0 and 10.0.
NOTE:
The HEADER TILT switch can be locked out to prevent inadvertent header angle changes when pressing the
HEADER HEIGHT control switches. Refer to
Activating the Header Tilt Control Lock Out, page 118 .
Checking Self-Locking Center-Link Hook
Periodically check the operation of the hook locking mechanism and ensure that it is working properly as follows:
169887 193 Revision A