MacDon M205 Operators Manual User Manual
Page 235
6. Adjust position of the center-link cylinder (A) with
the REEL UP and REEL DOWN switches. Position
the hook above the header attachment pin using the
HEADER TILT switches on the GSL.
IMPORTANT:
Hook release must be down to enable self-locking
mechanism. If the release is open (up), manually push it
down after hook engages header pin.
7. Lower center-link (A) onto the header with REEL
DOWN switch until it locks into position (hook
release [B] is down).
8. Check that center-link is locked onto header by
pressing the REEL UP switch on the GSL.
Figure 4.141: Hydraulic Center-Link
9. Start engine and press HEADER UP switch (A) to raise
header to maximum height.
NOTE:
If one end of the header does NOT raise fully,
the lift cylinders require rephasing. If rephasing
is needed, proceed as follows:
a. Press and hold the HEADER UP switch until
both cylinders stop moving.
b. Continue to hold the switch for 3–4 seconds.
Cylinders are now phased.
Figure 4.142: GSL
169887
219
Revision A