MacDon M205 Operators Manual - Manual (Page 214)

OPERATION
4.4.8 Auto Raise Height
The header can be automatically raised if programmed into the cab display module (CDM).
Refer to the following topics:
• Programming the Auto Raise Height Feature, page 198
• Using the Auto Raise Height Feature, page 199
Programming the Auto Raise Height Feature
Figure 4.89: Operator Console
A - Return to Cut B - Program C - Select D - Right Arrow
E - Left Arrow F - Header Up G - Header Down
Program the AUTO RAISE HEIGHT feature as follows:
NOTE:
RETURN TO CUT switch (A) can be OFF or ON.
1. Press PROGRAM (B) and SELECT (C) on cab display module (CDM) to enter programming mode.
2. Press SELECT (C). WINDROWER SETUP? is displayed on upper line (B).
3. Press right arrow (D), then SELECT. SET KNIFE SPEED? is displayed.
4. Press SELECT (C) until AUTO RAISE HEIGHT is displayed.
5. Press left arrow (E) or right arrow (D) to change value on lower line. Working range is 4.0 to 9.5. At 10.0, the
feature is disabled and “OFF” is displayed.
6. When finished entering desired values, press PROGRAM to exit programming mode.
169887 198 Revision A