MacDon M205 Operators Manual - Manual (Page 118)

OPERATOR’S STATION
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed.
Figure 3.105: CDM Programming Buttons
4. Press SELECT (D) until RETURN TO CUT MODE? is
displayed on the upper line.
• HEIGHT & TILT or HEIGHT ONLY will be displayed
on the lower line.
5. Press left (B) or right (C) arrows to select return to cut
mode. Press SELECT (D).
6. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
Figure 3.106: Setting Return To Cut Mode
Setting the Header Cut Width
NOTE:
• Header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to 4.5 Attaching and
Detaching Headers, page 202 .
• Header Cut Width is less than actual header width to accurately measure number of acres cut.
169887 102 Revision A