MacDon M205 Operators Manual - Manual (Page 85)

OPERATOR’S STATION
Display Selector Switch
Pressing the display selector switch (A) selects and
displays the settings on the cab display module (CDM) top
line read-out for each of the header controls.
Press switch (A) to scroll through settings.
Figure 3.55: GSL
Reel Position Switches
The functions performed by the reel position switches
depend on which header is attached and the cab display
module (CDM) programming.
• For functions related to Double Windrow Attachment
(DWA) position, refer to:
– 4.4.10 Double Windrowing, page 200
• For functions related to Reel Fore-Aft position and height
on Draper headers, refer to:
– 4.6.3 Adjusting the Reel Fore-Aft Position, page 249
– 4.6.4 Adjusting the Reel Height, page 249
• For the Center-Link Assist Cylinder, refer to the section
appropriate for your header:
– 4.5.3 Attaching an A-Series Header, page 216
– 4.5.1 Attaching a D-Series Header, page 202
– 4.5.5 Attaching an R-Series Header, page 232
NOTE:
For detailed switch operating modes, refer to the section
in this manual, specific to your header.
Figure 3.56: Ground Speed Selector
A - Reel Down B - Reel Forward
C - Reel Up D - Reel Aft
169887 69 Revision A